top of page

Concrete Tile Roof

On site Estimate Inspection - Concrete Tile Roofing

  • 1 h
  • Free Estimate
  • Location 1

Service Description

- Lift of existing tile, removal of existing concrete flashing, cement flashing and underlayment materials to plywood decking. - Replacement of any damaged or deteriorated plywood decking at an additional cost per four-foot by eight-foot sheet of plywood needed (OSB 7/16 plywood decking) Replacement of any damaged or deteriorated starter board at an additional cost per linear foot needed. Decking will be replaced in whole sheets only in accordance with recommendations by both the National Roofing Contractors Association (NRCA) and the American Plywood Association (APA). New decking shall be APA rated for structural use. Deck fastening will meet or exceed local building code requirements and H-clips will be used between all rafters. - Replacement of following flashing materials, installation of bottom galvanized steel flashing, and top aluminum cap flashing for all penetrations: step flashings, collars, pipe jacks, chimney Saddle flashings, Tile Pans, counter flashings, perimeter drip edge material as needed. All materials to meet or exceed manufacturer's requirements and to be installed "hidden nail" fashion so that no "shiners" are present. -Installation of new Soleil Flashings along ridge and rakes to replace concrete flashings - Installation of two layers of Malarkey #40 Lb Underlayment as a base. Felt will be fastened using 1-inch plastic-capped nails with a 1-inch diameter head. Fasteners shall be at 12-inch centers along the side and end laps and at 24-inch centers in two staggered rows in the center of the roll. Each center row will be approximately 12 inches from the side of the sheet. Higher Levels Roofing - Paint all vent flashings, roof penetrations, and drip edge. Replacement of following flashing materials: bird stop. Drip edge shall match fascia color. Color of roof penetrations and flashings to be chosen by owner. - Reinstallation of existing roofing tiles. Installation of ridge to eave intersections Tiles will be installed in strict accordance with the manufacturer's specifications and shall be fastened using one nails per tile. OPTIONAL: POWER WASH


Contact Details


bottom of page